Worldwide Engineering, Environmental, Construction, and IT Services
Services
Safety and Industrial Hygiene- Asbestos Management
- Construction Safety Management
- Environmental, Health, and Safety Training
- Ergonomic Assessments and Physical Demands Analysis
- Incident Reporting and Investigations
- Indoor Air Quality Evaluations
- Material Safety Data Sheet
- Microbiological (Mold) Remediation Services
- Occupational Exposure Assessments
- Safety and Health Auditing
- Safety and Health Program and Procedure Development
Agricultural ServicesAir QualityBrownfield Redevelopment ServicesBuilding SciencesConstructionData ManagementDecommissioning ServicesDrilling ServicesEmergency Management/ Response/CFATSEnergy ServicesEngineering
Environmental Site Assessment and RemediationGeotechnical and Materials EngineeringGreenhouse Gas Assurance ServicesHydrogeologyInformation TechnologyInsurance Support ServicesMunicipal Infrastructure Planning and DesignNoise and Vibration ConsultingRailroad ServicesRisk AssessmentSafety and Industrial Hygiene
Microbiological (Mold) Remediation Services
Microbiological (Mold) Remediation Services
CRA's expertise in this field has been demonstrated by the completion of over 1,000 mold assessments in Canada and the United States. Typical services are summarized below.
Microbiological (Mold) Assessment
- Review of site history
- Property and building inspections
- Identification of the sources and causes of water infiltration and/or damage
- Mechanical heating ventilation and air conditioning (HVAC) system inspections
- Bulk, surface, and air sampling
- Moisture, temperature, and humidity measurements
- Determination of the extent of mold contamination on or in building components, furnishing, and fixtures
Microorganism Detection and Identification
- Broad range of environments and matrices
- Advanced organism recovery and identification
- Wide range of mold species and subspecies
- Specialized analytical techniques
Air Quality Assessment
- Bioaerosol sampling
- Depositional sampling
- Liquid impinger sampling
- Contaminant source identification
- Exposure risk evaluation
Remedial Design
- Removal of contaminated building components
- Chemical decontamination of building component surfaces
- Removal of water/moisture and drying out wet or damp areas
- Installation of new wiring, plumbing, HVAC system components, and wall/floor surfaces
- Installation of new furnishings and fixtures
- Repairs/sealing of areas to prevent future water intrusion
Expert Testimony/Litigation Support
- Cost recovery actions
- Environmental compliance issues
- Insurance recovery actions
- Cost allocation
- Remedial action evaluation
- Responsible party identification
